Operation
14
4
3. Line up the paper with the desired mounting location and mark (with a
pencil) on the wall the positions of the mounting holes
6
(see
Fig. 4
).
Make sure the mounting holes are marked horizontally.
4. Using an electric drill
32
, drill holes in the wall at the marked locations.
5
0.2 in (5 mm)
18
19
5. Insert the wall anchors
18
into the drilled holes and drive the screws
19
into the wall anchors using a Philips screwdriver
33
(see
Fig. 5
).
Leave no more than 0.2 inches (5 mm) between the heads of the screws and
the wall (see
Fig. 5
). This minimizes the inclination angle of the product.
6. Mount the product on the wall by guiding the heads of the screws into the
mounting holes
6
.
Operation
• Make sure all desired cable connections and the power
connection are properly made before operation (see chapter
“Audio connections” and “Power connection”).
• The indicator light
31
of the remote control
21
blinks once
when a button is pressed. Make sure there is no obstruction
between the product and the remote control during use. The
maximum distance between the two parts should not be
greater than 33 feet (10 meters).
