UK/ N. IRELAND HELPLINE 0871 3761020
(costs 7p/min from BT landline, mobiles costs may be higher)
REP. IRELAND HELPLINE 1-800-992508
5
Repair
Leave the repair of your TFT monitor exclusively to qualified specialist personnel.
Please contact our authorised
Service Partners
exclusively in the case of a necessary repair.
Caution! Pay attention to the surrounding temperature!
The TFT monitor can be operated at a surrounding temperature from 0° C to +40° C and at a relative
ambient moisture level of < 80% (non-condensing).
The TFT monitor can be stored at -20° C to +60° C when it has been turned off.
Danger! Pay attention to the following:
Wait to bring the device into operation until it has reached the surrounding temperature,
after the TFT monitor has been transported.
Moisture, which can cause an
electrical short-circuit
, can form within the TFT monitor in
the case of wide
variations in
temperature or moisture
.
Warning! Pay attention to safety during the connection!
Power supply
Please pay attention:
Parts of the device will be subject to voltage, even if the mains switch has
been switched off.
Pull the mains plug from the socket
, to interrupt the power supply to your TFT
monitor or to release the device from voltage completely.
Only operate the TFT monitor at an earthed socket with
100-240V~, 50/60 Hz.
Ask your energy supplier if
you are not sure about the power supply at the set-up location.
We recommend the use of
protection against excess voltage
for additional safety, in order to protect your
TFT monitor against damage because of
voltage peaks
or
electrical
flashes
on the mains network.
Pull the mains plug from the socket, in order to
interrupt
the
power supply
to your monitor.
The
socket
must be located close to the TFT monitor and be
easily accessible
.
Lay the cable so that no-one can tread on it or trip over it.
Do not place
any objects on the
cable, because it could be damaged otherwise.
Your device has an On/Off switch. The TFT monitor can be switched on and off by means of it.
No power
will be consumed if the switch is standing at
OFF
(0). Put the On/Off switch to
OFF
or use a master/slave
power strip, in order to avoid power consumption when the device is switched off.
