114 of 124
9. Switching the device on/off
Switch the device on using the power switch at the side of the unit.
Press the
button on the device for approximately 2–3 seconds or the
button on the remote control to switch on the radio.
Press the button again to switch to standby mode.
NOTICE
The time is displayed in standby mode.
To switch the device off completely, switch the power switch to the
OFF
position.
10. Adjusting the aerial
Unwind the wire aerial fully.
Adjust the wire aerial to get optimal reception.
The bar display gives the current signal strength.
11. Setting the volume
Press the
+
button on the remote control or turn the
-
dial in a
clockwise direction to increase the volume.
Press the
–
button on the remote control or turn the
-
dial in an an-
ti-clockwise direction to reduce the volume.
A status bar on the display indicates the volume level.
12. Settings
Before you can make settings, you need to make sure the device is switched on or in
standby mode. System settings are only possible if the device is switched on.
Any settings you make are retained in standby mode.
Proceed as follows to make settings:
Press the
button on the device or the
MENU
button on the remote
control.
Press
/
on the device or on the remote control to
navigate within the menu.
Press
OK
to confirm your menu selection.
Press
INFO
to return to the higher-level menu.
12.1. Setting the timer
You can set a timer of up to two hours (maximum).
Select
SET EGG TIMER
.
Press
/
on the device or on the remote control to
set the hour, minute and second.
84954 MULI eCommerce Content Final REV2.indb 114
84954 MULI eCommerce Content Final REV2.indb 114
09.07.2015 08:51:51
09.07.2015 08:51:51
Summary of Contents for LIFE E66314
Page 27: ...28 von 124 ...
Page 99: ...100 af 124 ...
Page 123: ...124 of 124 Letzte Seite ...
Page 124: ...08 2015 ...