Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 83388
22
Learn function
12
You can manually save the functions of an original remote control to your universal
remote control. Commands are saved to the mode key on which the device of the
original remote control was programmed.
The universal remote control can “learn” up to 150 commands.
Notes on learn function
•
Use new batteries for both remote controls.
•
If you start programming from the start
– especially after the first operation – delete all saved commands first of all (see
“Deleting commands for all mode keys” on page 24).
•
Only one original remote control can be programmed on each mode key.
•
If you would like to program an original remote control to a mode key, first delete the
commands on this mode key (see Deleting commands for only one mode key on page
24).
•
The
LEARN ERROR
message is displayed if the memory is full. If this happens, delete saved
commands.
•
Programming each key can take approx. 3 seconds. Do not release the key to be learned
before the
SUCCESS
or
LEARN ERROR
message appears.
•
The following keys cannot be assigned to functions:
Setup
,
MACRO
and all mode keys.
•
Some original remote controls (for DVD, video recorder, SAT) can themselves be
programmed with the device codes of some TV brands to carry out basic TV set
functions (volume, mute, channel search).
Do not attempt to transfer the functions of an original remote control that has been
programmed with the code of a different TV set to your universal remote control. This
could cause programming errors.
•
First try to program two or three commands and then test them.
•
Before programming in your commands, first delete all existing commands (see “Deleting
commands for all mode keys” on page 24).
Do not execute the learn function under a low-energy lamp. Such lamps (e.g.
fluorescent lamps) can contain infrared light components that could influence the
learn function.
