LinkIt 2523 HDK v11 User's Guide
© 2015 - 2016 MediaTek Inc.
Page 29 of 82
This document contains information that is proprietary to MediaTek Inc. (“MediaTek”) and/or its licensor(s).
Any unauthorized use, reproduction or disclosure of this document in whole or in part is strictly prohibited.
4.12.
US
B
LinkI
t
2523
HDK
has
two
USB
conn
ector
s,
25
23
USB
see
secti
on
and
MK
20
USB
see
secti
on
”, as shown in Figure 3. The
2523 USB
connector is used to flash the board with the LinkIt 2523 Flash Tool.
The
MK20 USB
is for CMSIS-DAP USB and serial port communication and setting up the board as a mass storage
device. The
is the debugging user interface for embedded devices. The mass storage is for flashing the
LinkIt 2523 using the SWD interface. The user can drag and drop the LinkIt 2523 binary file and the FreeRTOS
1, as shown below.
Camera data line 0 or
sensor daughterboard
clock
Set the jumper J1010 to connect the sensor daughterboard using the SPI
clock, as shown below.
Set the jumper J1010 to connect the camera daughterboard using data line
0, as shown below.
Camera pixel clock input
or sensor daughterboard
data input
Set the jumper J1011 to connect the sensor daughterboard using the SPI
data input, as shown below.
Set the jumper J1011 to the camera daughterboard using pixel clock input,
as shown below.
Camera pixel clock output
or sensor daughterboard
reset
Set the jumper J1012 to connect the sensor daughterboard connection
using the GPIO, as shown below.
Set the jumper J1012 to connect the camera daughterboard using the
camera pixel clock output or data line 0, as shown below.
Camera pixel clock output
/ camera data line 2
Set the jumper J1015 to connect the camera daughterboard using the
camera pixel clock output, as shown below.
Set the jumper J1015 to connect the camera daughterboard using the
camera data line 2, as shown below.
1 2 3
1 2 3