9
silverlight - manual of use and maintenance
Description of signaling for the recharging unit:
(Table 1)
:
Green Power
LED
Battery LED
Green Red
Position of
Silverlight in the
recharging unit
Function
ON
OFF
OFF
Not in place
Recharging unit powered
ON
ON
OFF
In place
Battery being recharged
ON
OFF
OFF
In place
Recharging completed.
Battery charged.
ON
OFF
ON
In place
Battery failed.
ON
OFF
ON
Not in place
Electric contacts of the
recharging unit short-
circuited.
�
WARNING: Do not tamper with the recharging unit electrical contacts.
The recharging unit recognizes the battery state. If after some exposure cycles the battery is not flat
enough when the handpiece is placed on the recharging unit, the green battery LED does not switch on.
This is normal.
Description of the acoustic signals of the handpiece:
(Table 2)
Function
Push-button control
Acoustic signal
FAST
polymerisation
Brief pressure of push
button
1 beep
on starting exposure
1 beep
on completing exposure (10
seconds)
SLOW RISE
polymerisation
Pressure of push button
for at least 2 seconds
1 beep
when starting and
1 beep
after 2
seconds
1 beep
after 10 seconds of exposure
1 beep
on completing exposure (20
seconds)
Interruption of exposure
cycle
Pressure of push button
during exposure
1 beep
Battery low signal. The
residual charge is sufficient
for 6 cycles.
2 beeps
on completing the exposure
cycle
Battery dead signal
Pressure of push button
for FAST or SLOW RISE
polymerisation
2 beeps
- No light emission
Thermal protection signal
3 beeps
during the exposure cycle