4.2.2
4.2.3
Affix the short extension rod (30mm long) to the loadcell probe in the hole at the bottom of the gauge by
tightening it gently with the fingers.
Your chosen grip or accessory may now be connected to the extension rod.
Note:
Note:
When fitting a grip ensure that it is screwed finger-tight only. Excessive torque or overtightening can
damage the loadcell. Never fit any accessory without first sitting an extension rod.
Mounting to a test stand
On the rear of the gauge there are two M5 threaded holes, which can be used for mounting the gauge to a
Mecmesin test stand.
Each Mecmesin test stand is supplied with a dedicated ‘dovetailed mounting bracket’ and screws for this purpose.
If you wish to mount the gauge to another type of stand, ensure that the screws used are threaded into the gauge
to a
maximum depth of 10mm
maximum depth of 10mm
. If screws are fitted beyond this depth, damage to the loadcell will occur.
Powering up
As shown in Figure 1 the control panel has 5 Function keys plus an On/Off key:
To power up the gauge press the red
7
Summary of Contents for BFG 10
Page 16: ...Rear View 16 ...
