Air & Surface Steriliser System
REVISION: 04/2020 | page 8 of 16 INSTALLATION & OPERATING MANUAL
7.2 SERVICING INFORMATION
7.2.1 Inspection of area:
•
If you are carrying out a service check on a HyGenikx unit some time after installation please ensure
the area is safe and secure to work in.
Appropriate signage should be visible to warn public that work is being carried out.
•
Are there any obvious bad odour sources?
The HyGenikx unit will help to control odours but it is important that bad odour sources on site continue
to be addressed. Overflowing bins, unflushed toilets, leaks etc. should all be rectified. Refer to Section 9.2
for some useful check points.
7.2.2 Inspection of each unit:
•
Is the indicator illuminated on unit front, with lamp light also visible through the vents of unit?
If not please refer to Section 9.3 Lamp/Unit Failure Checklist.
•
Is there an odour present in the environment that you think is coming from the unit?
After installation it is not unusual for the unit to produce a slightly metallic odour within the first 48 hours
of use due to the lamp bedding in. If the unit is working correctly but odour remains after this time please
refer to Section 9.1.3.
•
Is the unit operational 24/7?
It is important to confirm with the site that the unit/power to the area is not disconnected at any point
(with units connected to lighting circuits – check turning lights off does not disconnect unit).
For technical assistance e-mail [email protected], quoting the HyGenikx model number. The model number
can be found on both sides of the unit.
