EHC
‐
PM
.
9
.
<LF>Time: hh:mm<CR><EXT>
<LF>Gross: xxx.xxx kg(or lb)<CR> <EXT>
<LF>Tare: xxx.xxx kg(or lb)<CR> <EXT>
<LF>Net: xxx.xxx kg(or lb)<CR> <EXT>
<LF>Unit price: xxxxxx.xx $/kg(or $/lb)<CR><EXT>
<LF>Total price: xxxxxx.xx $<CR> <EXT>
NOTE
：
The ID information can only be printed out after setting.
Press Enter key to confirm the input and go to the next step, or use ON/OFF EXIT key to exit this mode.
7. RS-232 connects between scale and host
：
SCALE(Indicator) -------CABLE
（
9 pins
）
----------------------------HOST
DB9(Female)-------------DB9(Male)--------DB9(Female)-----------DB9(Male)
PIN2 TXD------------------2--------------------2---------------------------PIN2 RXD
PIN3 RXD------------------3--------------------3---------------------------PIN3 TXD
PIN5 GND------------------5--------------------5---------------------------PIN5 GND
PIN4 DSR------------------4--------------------4---------------------------PIN4 DTR
PIN6 DTR------------------6--------------------6---------------------------PIN6 DSR
PIN7 CTS------------------7--------------------7---------------------------PIN7 RTS
PIN8 RTS------------------8--------------------8---------------------------PIN8 CTS
PIN1 NC--------------------1--------------------1---------------------------PIN1 NC
PIN9 NC--------------------9--------------------9---------------------------PIN9 NC
Note: PIN4 and PIN6, PIN7 and PIN8 are shorted in the scale!
8. RS-232 cable connects between scale and OS-2130D
：
9.
Date and time setting
1. Under the normal working mode, press and hold 5 and ON/OFF EXIT key for more than 3s to enter into this mode.
In this mode, you can set the system date and time.
（
Note: the date and time in scale will be lost after the scale
power off if no RTC module is installed
）
2. After entering into this mode, the WEIGHT window will display “Setup”, the UNIT PRICE window will display
“dAtE”(date, prompt to input date) and the TOTAL PRICE window will display the current date xx.xx.xx. Use the
