www.Me3D.com.au
This Getting Started guide is provided and maintained by Me3D.com.au
Page
5
of
13
P
UTTING HER TOGETHER
Prior to shipping, we have put your Me2 together, calibrated it and run a test print for you to make sure she is running
smoothly. You will need to do some minor re-assembly of her to get started.
C
ONNECT THE GANTRY
1.
Unpack the Upper Assembly and Lower Assembly.
2.
You will see a test print still on the print bed. Remove it and keep it aside, this will act as a guide to ensure you are
getting the best from your Me2 after re-assembly.
3.
Loosen slightly the four M5x12 screws retaining the Handle.
4.
Slide the Handle to the top of
the Z-Axis and tighten the
Screws using the 3mm Allen
Key.
5.
Lay the lower assembly on its
back. Remove the 2 M5x12
screws from the base of the
Upper Assembly. Slot the
alignment tab at the base of
Z-Axis on the Upper Assembly
into the alignment slot on the
Lower Assembly and fix it in
place using the 2 M5x12
screws, and tightening with
the 3mm Allen Key.
6.
At this point your Me2 is re-assembled and is ready to be connected to the host computer.
