4
Mounting and installation
Connecting the GPS Receiver to the terminal
18
V7.20160121
30302710-02-EN
You can find a list of on-board integrated display/controllers that we have tested here:
▪ Transfer target rates via LH5000 [
▪ Switching sections and transferring target rates via ASD [
For other on-board integrated display/controllers and for on-board integrated display/controllers with
other software versions, this function may not work at all or different from how it is described in these
instructions. Because the operating mode and configuration depends on the on-board integrated
display/controller, Müller-Elektronik can unfortunately not help you with their set-up. You must contact
the on-board integrated display/controller manufacturer for this.
On-board display/controller
Null modem cable
Adapter cable*
Available as a set with Cable 3, item number:
3032254800
Port B on the terminal
*When using an Amatron3 or as on-board integrated display/controller, you will only need a
traditional null modem cable. (Amatron3 and are on-board integrated display/controller
from Amazone)
Connecting the GPS Receiver to the terminal
Each GPS receiver which is connected to the terminal must fulfil the conditions in the table below.
GPS receivers which can be purchased from Müller Elektronik fulfil these conditions.
Technical requirements for using the DGPS Receiver
Operating voltage:
Supply voltage of the terminal – 1.5 V
Current consumption
Maximum 200 mA (at 70°C)
GPS standard
NMEA 0183
Refresh rates and signals
5 Hz (GPGGA, GPVTG)
1 Hz (GPGSA, GPZDA)
Transmission rate
19200 baud
4.8
Preconditions
