Tractor-ECU application
Configuring the parameters for a vehicle profile
8
30302710-02-EN
V7.20160121
59
5. When determining using the 100m method: The action sequence is shown on the terminal
OR
For manual input:
- Enter the desired value.
6.
- Return to the vehicle profile.
⇨
You have calibrated the speed sensor.
Configuring a working position sensor
If a working position sensor is connected to the terminal via connector B, you must tell the terminal
the principle according to which the sensor functions.
During the configuration, you can choose between three types of sensor:
▪ "analog"
You are using an analog working position sensor, which measures the height of the hitch linkage
as a percentage.
▪ "digital"
Use this option if the sensor mounted on your equipment is compatible with the Standard ISO
11786. The sensor is connected to the terminal via the signal socket.
▪ "ME-sensor Y"
You are using a working position sensor provided by Müller-Electronik. The sensor is connected
to the terminal.
You have connected a working position sensor directly to the terminal or via the signal socket to
the terminal.
You have selected the value "Hitch sensor - front" or "Hitch sensor - rear" in the "Working
position" parameter.
1. Call up the Tractor-ECU application:
| Tractor-ECU
2.
- Call up the list of vehicles.
3. Select the vehicle profile.
4.
- Press.
⇨
The following screen will appear:
5. Select a sensor type.
8.2.2
Procedure
