MDT Technologies KNX SCN-RT1UPE.01, Technical Manual

Page: 11 / 56

Technical Manual Room Temperature Controller SCN ‐ RT1
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
11
4 Reference ETS ‐ Parameter
4.1 General Settings
The following settings are available at the ETS ‐ Software:
Illustration 5: General settings
The chart shows the dynamic range of the general settings:
ETS ‐ text Dynamic range
[default value]
comment
Startup delaytime 0 ‐ 60s
[0]
Time between an upload and the
functional start of the device
Select hardware

SCN ‐ RT1xP.xx without manual control

SCN ‐ RTxPE.xx with setwheel

SCN ‐ RTxPD.xx with display

SCN ‐ TS1UP.01 without controller function
Adjustment of the used device
Chart 3: General settings
The parameter startup timeout adjusts the time between an upload and the functional start of the
device. The used hardware reacts only after expiration of the adjusted time. All input commands
before the startup timeout expire.
Additional, you have to select the used hardware at this menu.
There are additional settings at the devices with setwheel and display. These settings are described
at the following segments.
The SCN ‐ TS1UP.01 is a pure temperature sensor, which does not contain of any controller functions.
When this hardware is selected, only the menus “Setup general“(4.1), “Temperature measurement”
(4.2) and “Alarm/Messages” (4.3) are shown and can be parameterized.