10
control panel.
If you want to change the angle of the control panel, pull
the lever while changing the angle of the panel. See the
illustration above.
Seat height adjustment
To change the seat height:
Remove the seat from your wheelchair. Press and hold the seat lock lever to unlock
it, then unscrew and remove the seat from the wheelchair.
Remove the front cover.
Adjust the height of the element retaining the seat to the desired position.
Insert the locking pin and secure the seat retaining element as shown in the figure
below.
Replace the cover and reinstall the front seat.
Backrest adjustment
To adjust the angle of the backrest:
Pull up the lock lever blocking the backrest to unlock it
as shown in the figure below,
Adjust the backrest in the desired position.
Release the lever to once again lock the backrest.
When adjusting the angle of the backrest always lean back
against the backrest.
11
Do not drive the wheelchair when the backrest is heavily tilted back.
Swivel seat
This feature is intended to facilitate the transfer from and to
the wheelchair.
To rotate the seat, pull up the plastic lever on the side of the
seat (A). Turn the seat in the desired direction (B or C). Sit
on the seat and turn around on the seat to its original
position and release the lever. Make sure that the seat is
blocked in place after the release of the lever
–
the seat does
not move in any direction.
It is very important to properly block the seat in place as its rotation during the
operation of the wheelchair could lead to driver's fall and injury.
Adjustment of the headrest
You can adjust the height of the headrest so that it corresponds to your needs and safety
rules.
In order to change the setting of the headrest (height of the headrest) press button shown
on figure B1 at the same time changing the height of the headrest.
Adjustment of the width of the armrest
To adjust the width of the armrests:
Remove the screw (A) located at the back of the seat frame.
pannello di controllo.
Se si desidera modificare l’angolazione del pannello di
controllo, tirare la leva mentre si modifica l’angolazione
del pannello. Vedere l’illustrazione.
Regolazione dell’altezza del sedile
Per cambiare l’altezza del sedile:
• Rimuovere il sedile dalla sedia a rotelle. Premere e tenere premuta la leva di blocco
del sedile per sbloccarlo, quindi svitare e rimuovere il sedile dalla sedia a rotelle;
• Rimuovere il coperchio anteriore;
• Regolare l’altezza dell’elemento mantenendo il sedile nella posizione desiderata.
• Inserire il perno di bloccaggio e fissare l’elemento di fissaggio del sedile come mo-
strato nella figura seguente;
• Sostituire il coperchio e reinstallare il sedile anteriore.
Regolazione dello schienale
Per regolare l’inclinazione dello schienale:
• Sollevare la leva di blocco bloccando lo schienale per
sbloccarlo come mostrato nella figura in basso;
• Regolare lo schienale nella posizione desiderata;
• Rilasciare la leva per bloccare nuovamente lo schienale.
Quando si regola l’angolazione dello schienale, appoggiarsi
sempre contro lo schienale.
