www.marketdirect.com.au
I
Ph: 1300 494 494
I
©Copyright
I
P a g e
|
33
Protecting from Mould
Mould is very difficult to clean once a tent is
affected. There are several ways you can prevent
the occurrence of mould on your canvas.
Never leave your camper packed away wet. If you
must leave a campsite with wet canvas, be sure to
open and dry out your tent thoroughly at the very
first opportunity when you get home. Mould can
develop in just a couple
of days so don’t take the risk.
When packing up even a dry tent it is important to check under the mattress that there is no build-up of
condensation overnight. Body heat on a mattress can create enough temperature difference with the exterior for
moisture to form under it. If left unchecked this can cause mould when your camper is stored. Bird droppings can
damage your canvas due to the Ph level. Always clean off any animal dropping as soon as possible.
When storing your camper between camping trips it is recommended you pack a couple of moisture absorber
packs into your camper. On soft floor campers these are best placed beside the mattress, on hard floor camper
they should be packed inside the main body. Using these packs is critical in tropic regions due to the humidity as
when the inside temperature of the camper drops overnight, the moist air can turn into condensation which in
turn will cause mould.
Maintenance
Maintenance is essential to keep your camper in a safe and usable condition. Campers are no different to any
other motor vehicle and require servicing at regular intervals which may vary according to use and the
environment in which it is used. The service schedule outlines the service intervals for safe travelling and your
owner obligations under our warranty policy. Servicing should always be carried out by a competent person with
relevant experience.
WARNING
:
•
Never work beneath the camper while suspended on a jack. Always use “Jack Stands” with an adequate SWL.
•
Always use dedicated jacking points
•
240volt appliances and wiring must only be serviced and repaired by a qualified tradesperson.
•
Gas plumbing must only be serviced and repaired by a qualified gas fitter
Summary of Contents for Robson XTT 2015
