CSP−HMI−2
MD Helicopters, Inc
.
MAINTENANCE MANUAL
67−10−00
Page 417
Revision 29
CYCLIC STICK
ASSEMBLY
LATERAL CYCLIC
BELLCRANK
STRAP
LATERAL CONTROL ROD
(NOTE 2)
QUICK RELEASE
PIN
QUICK
RELEASE
PIN
SLOTTED BUSHING
(NOTE 1)
NOTES:
1. EDGE OF BUSHING MUST PROTRUDE A MINIMUM
OF 0.010 IN. (0.254 MM) TO A MAXIMUM OF 0.060 IN.
(1.524 MM) ABOVE OUTSIDE SURFACES OF PART
AFTER NUT IS TIGHTENED.
2. CONTROL ROD END BEARINGS MUST NOT JAM
THROUGHOUT FULL RANGE OF LONGITUDINAL
TRAVEL (34
°
).
G67−1008A
Figure 409. Cyclic Stick Assembly Installation (Inboard)
14. Cyclic Control Stick Replacement
(Outboard)
A. Cyclic Control Stick Removal (Outboard)
(1). Disconnect control stick electrical plug.
NOTE:
Omit steps (2). and (3). below to remove
stick without removing stick socket.
(2). Remove cotter pin, nut, washers and
bolt securing copilot’s lateral control rod
to stick socket.
(3). Remove cotter pin, nut, washers and
bolt attaching stick socket to end of
cyclic torque tube. Remove stick tube
with stick socket attached.
(4). Remove two quick−release pins attach-
ing stick tube to stick socket.
(5). Remove stick tube from socket.
B. Cyclic Control Stick Installation
(Outboard)
(1). Insert stick tube into stick socket and
install two quick−release pins.
NOTE:
Omit steps (2). thru (4). when installing
stick without socket.
(2). Position cyclic stick to align holes in
socket with mating holes in torque
tube.
(3). Install bolt, two washers, nut and new
cotter pin.
(4). Check that slotted bushing is in place;
then align copilot’ s lateral control rod
with stick socket. Install bolt, two
washers, nut and new cotter pin.
(5). Connect electrical plug.
