PELLET STOVES
Chapter 4
INSTALLATION AND USE MANUAL
page
29
Operation
Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
B
C
4.9.
HOT AIR VENTILATION
The
KAIKA OYSTER
stove is equipped with an inner fan for the
expulsion of the hot heating air that can be adjusted indifferently if the
stove is in manual or automatic mode.
5
speeds can be selected as well as an automatic function.
To select the speed, after pressing the bottom right button, press it
again to increase or decrease the fan power.
In addition to
5th speed
there is an additional selection called
AUTO
function. This function lets you connect the fan speed to the flame
power. With this option selected, the stove will independently select the
fan speed based on the flame power.
Such function allows ventilation speed to be "connected" to the flame
power with a maximum of V3. When such operation is selected the
stove shall independently select fan speed according to flame power up
to a maximum of V3 (P1=V1; P2=V2; P3=V3; P4=V3; P5=V3) to avoid
noise.
4.10.
Room sensor
The room probe (
B
) is located at the back of the stove;
should this be
near the fumes exhaust tube
, we recommend to extract the room
probe so that it sticks out by approximately 10 cm.
In this way it does not detect the temperature of the stove. It is
advisable to do this operation during installation, since before extracting
the probe (
B
) it is necessary to take off the clamp (
C
) that keeps it
connected; which can be done directly on the card.
To extract the probe (
B
) it is necessary to unscrew the protection cap
(
A
) and slowly pull the probe (
B
). After extracting the probe (
B
)
sufficiently, close the protection cap (
A
) again.
ATTENTION! Once the clamp that binds the probe wire
is taken off, avoid it coming into contact with the hot
parts of the stove.
A = PROTECTION CAP
B = PROBE (FLUSH)
C = CLAMP
