![MCZ JAZZ Hydromatic 30 Acs H1 Installation Manual Download Page 39](http://html1.mh-extra.com/html/mcz/jazz-hydromatic-30-acs-h1/jazz-hydromatic-30-acs-h1_installation-manual_1756384039.webp)
37
10-HYDRAULIC CONNECTION
Technical Dept. - All rights reserved - Reproduction prohibited
CONNECTING THE SYSTEM
Make the connections to the corresponding fittings shown in the diagram on the previous pages. Make sure the pipes are not placed under
tension or undersized.
IT IS STRONGLY RECOMMENDED TO WASH THE ENTIRE SYSTEM BEFORE CONNECTING THE STOVE IN ORDER TO GET RID
OF RESIDUES AND DEPOSITS.
Always install shutters in the system leading to the stove so as to disconnect it from the hydraulic system should it be
necessary to move it, or when it requires routine and/or special maintenance. Connect the stove using flexible pipes
so that the stove is not excessively constrained to the system, and to allow slight movements.
The pressure discharge valve (C) is always connected to a water drain pipe. The pipe must be adequate to support the
water’s high temperature and pressure.
CLEANING THE SYSTEM
It is mandatory for the connections to be easy to disconnect by way of unions with rotating connections.
Install suitable shutters to cut off the tubes from the heating system. Assembling the safety valve on the system is compulsory.
In order to protect the heating system from damage caused by corrosion, incrustation or deposit build-up, it is important to clean the
appliance before installation, using suitable products, in compliance with Standard
UNI 8065 (water treatment of thermal plants for civil
use)
.
The use of FERNOX PROTECTOR F1 product (available at our authorised centres) is recommended, this provides long-term protection of
heating systems against corrosion and calcium build-up. It prevents the corrosion of the metal parts of the appliance, i.e. the ferrous
metals, copper and copper and aluminium alloys. It also reduces the noise produced by the boiler. Refer to the instructions on the product.
Cleaning should be performed by a qualified technician.
We also recommend the use of FERNOX CLEANER F3 and LEAK SEALER F4, always available from our authorised distribution centres.
FERNOX F3 is a neutral product for rapid and efficient cleaning of heating appliances. It has been designed to eliminate residues, oily
deposits and incrustations from existing appliances of all ages. It can help restore the heating efficiency of the boiler and reduce the noise
it generates.
FERNOX F4 is intended to be used with all heating appliances to seal micro fractures that cause small and inaccessible leaks.
FILLING THE SYSTEM
To fill the system, the stove can be equipped with an end piece (optional) with a non-return valve for manual filling of the heating system
(if the optional is not installed, the filling tap on the main boiler will be used). During this operation, any air in the system is released from
the automatic vent “
G
” at the top of the boiler body.
The valve is underneath the front panel, just lift the cover.
To allow the valve to vent, it is recommended to loosen the side cap (see figure). The filling pressure of the system
WHEN COLD
must be
1
bar
. During operation, if the system pressure drops (due to evaporation of dissolved gases in the water) to values lower than the minimum
indicated above, the user must use the filling tap to bring the pressure back up to its normal pressure.
For proper operation of the stove
WHEN HOT
, the pressure in the boiler must be
1.5 bar
.
Upon completion of this operation, always close the filling tap.
It is normal to hear noises and gurgling until all the air in the system is released.