MCZ GARDENIA, Installation And User Manual

Page: 59 / 68

57
13-PROBLEMS/CAUSES/SOLUTIONS
ATTENTION:
All repairs must only be carried out by a specialised technician, with the product switched off and the plug
disconnected.
If the product is NOT used as described in this instruction manual, the manufacturer declines all liability for any
damage caused to persons and property.
ANOMALY POSSIBLE CAUSES SOLUTIONS
Pellets are not being fed into
the combustion chamber. The pellet hopper is empty Fill the hopper with pellets.
Sawdust has blocked the feed screw Empty the hopper and remove the sawdust
from the feed screw by hand.
Faulty gear motor
3FQMBDFUIFHFBSNPUPS
Faulty electronic board
3FQMBDFUIFDJSDVJUCPBSE
The fire goes out or
the
appliance stops
automatically.
The pellet hopper is empty Fill the hopper with pellets.
The pellets are not fed See the previous anomaly.
The pellet temperature safety probe has been
triggered Let the product cool down, restore the
thermostat until the problem is resolved and
switch the product back on. If the problem
persists contact Technical Assistance.
The door is not closed properly or the gaskets
are worn
$MPTFUIFEPPSBOESFQMBDFUIFHBTLFUTXJUI
PSJHJOBMPOFT
Unsuitable pellets Change the type of pellets with those
recommended by the manufacturer.
Low pellet supply
)BWFUIFGVFMøPXDIFDLFEGPMMPXJOHUIFCPPLMFU
JOTUSVDUJPOT
The combustion chamber is dirty Clean the combustion chamber, following the
booklet instructions.
Clogged outlet Clean the smoke duct.
Faulty smoke extraction motor
$IFDLUIFNPUPSBOESFQMBDFJUJGOFDFTTBSZ
Pressure switch faulty or defective
3FQMBDFUIFQSFTTVSFTXJUDI
The product works for a few
minutes and then switches
off. Start-up phase is not completed Repeat start-up.
Temporary power cut Wait for the automatic restart.
Clogged smoke duct Clean the smoke duct.
Faulty or malfunctioning temperature probes
$IFDLBOESFQMBDFUIFQSPCFT
Faulty spark plug
$IFDLUIFTQBSLQMVHBOESFQMBDFJUJGOFDFTTBSZ
Technical Dept. - All rights reserved - Reproduction is prohibited