MCZ GARDENIA, Installation And User Manual

Page: 53 / 68

51
12-MAINTENANCE AND CLEANING
ATTENTION!
All the cleaning operations of all parts must be performed with a completely cold product and the plug disconnected.
5IFQSPEVDUSFRVJSFTMJUUMFNBJOUFOBODFJGVTFEXJUIDFSUJöFEIJHIRVBMJUZQFMMFUT
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
BEFORE EACH START-UP
Clean the ash and any deposits in the brazier that could clog the air passage holes.
If the pellets in the hopper finish, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier before starting-
up.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE START-UP AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specific detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass spray cleaner on the painted parts or the door gaskets
(ceramic fibre cord).
&9".1-&0'"$-&"/#3";*&3 &9".1-&0'"%*35:#3";*&3
Technical Dept. - All rights reserved - Reproduction is prohibited