www.mcohome.com
User Manual
MCOHome Technology Co., Ltd 2015
2
Before installation, please confirm the real voltage complying with the device’s specification.
Cut off any power supply to secure the safety of people and device.
During installation, protect the device from any physical damage by dropping or bumping. If
happens, please contact the supplier for maintenance.
Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid damage.
Avoid overexertion during operation, to protect device from mechanical damage.
Read all instructions and documentation and save for future reference.
Installation & Wiring
Location:
Thermostat is suggested to be installed indoor, a place with around 1.5m height above the floor
where represents the average room temperature. It should be away from direct sunlight, any cover, or
any heat source, to avoid false signal for temperature control.
CAUTION: Cut off power supply at circuit breaker or fuse before installation to avoid fire, shock
or death!
Step 1:
Remove the steel frame from the device, and secure it onto the junction box with two screws.
Step 2:
Insert all wires into the right terminals and tighten screws. The wiring diagram is shown below.
Step 3:
Attach the wired device on “A” points of the steel frame as shown first, and then push the
whole device into junction box.
Step 4:
Confirm the device is well mounted, power on and it is ready to operate.
