McLaughlin Vision GX2, Operation Manual

Page: 13 / 37

- 11 -
Setting the Time and Date
a)
Power on while holding Mode , wait for clock display appears.
The year will flash.
Press ▼ Gain to advance the year or ▲ Log to decrease the year.
b) Press Mode , the month will flash.
Press ▼ Gain to advance the month or ▲ Log to decrease the month.
c)Do same as above to set Day - -> Hour - - > Minute.
When measurement starts, setting is completed.
2) Battery compartment
Replace all batteries when there is a low battery condition.
Use six 1.5V alkaline type AA (IEC LR6/NEDA15A).
3) PC interface connector
4) Earphone plug
Earphone can be used in a noisy area.
Supplied as an option.
5) Sensor connector (
Signal input terminal
)
Used with Sensor Coil to find wiring
systems in a building or overhead telephone cables.
Sensor coil is supplied as options.
6) Digital level
Displayed the inclination of the receiver.
MODE
Battery 0 ％
Battery 100
％
Open
ALWAYS CHECK THE BATTERY POLARITY
BEFORE CLOSING THE COMPARTMENT
Battery holder
The connector is used to communicate PC and GPS.
*Interface cable & GPS are supplied as option.
Earphone plug
Sensor connector
PC interface connector
Calibration methodology of digital level
a) Power on while holding Depth key.
PUSH GAIN is indicated in 1 seconds.
b) Hold the receiver vertical position. (center of left chart)
c) Press
▼GAIN . Please do not move the receiver until OK is
displayed.
d) Press ▼GAIN again. Incline the receiver to the front, back,
left and right, and confirm the display.
The setting is memorized with Power off.