McLaughlin MCL 36C, Repair Manual

Page: 83 / 90

REPAIR INSTRUCTIONS
McL 36/42C
5.5.2
10. If tool does not slide on, loosen but do not remove the four
(4) bolts that attach the pump mount to the engine.
11. When the alignment bar slides on and off of the pulley
flange pilot, the pump mount is properly aligned.
12. Leave the alignment tool in place and tighten the four (4)
loose bolts on the engine. (Torque bolts to 124 ft lbs.).
Once mount is in place, the tool should be easily removed.
If binding occures, return to step eleven (11).
13. Remove alignment pulley flange.
14. Apply removable Loctite to the four (4) bolts that attach the
pulley flange to the engine pulley and tighten.
15. Put nylon sleeve onto the pulley hub. Pilot the pulley hub
and sleeve onto the pulley flange. Apply removable Loctite
to the four (4) bolts and tighten .
16. Apply a light coat of anti-sieze to the splined pump shaft.
17. Put the coupling hub onto the pump shaft.
18. Slide the pump and coupling hub through the pump
mount into the nylon sleeve. (Note: The coupling hub
may need to be rotated in order to go in the nylon sleeve).
19. Tighten the two (2) bolts and lockwashers that attach the
pump to the pump mount.
10
17
18