McLaughlin MCL 36C, Repair Manual

Page: 67 / 90

Before commissioning, leave
the fluid container of the ether
starting system in position for
15 minutes. Check for leaks.
The starting fluid is inflammable. Ensure
that the container is not damaged. Prevent
foreign substances from entering the
container. The fluid container must not be
stored at temperatures about 50 deg. C.
Never disconnect the cable between
battery, alternator and regulator while
the engine is
running.
Be sure not to confuse the battery
terminals.
If, however, it is necessary to start and
operate the engine without the battery,
disconnect the regulator from the
alternator before starting.
After transportation and before
commissioning of the engine:
Remove transport eyes 2.
In case of electric welding connect
ground terminal on the welder
directly to the piece being welded.
Always use proper lifting tackle 1
when transporting the engine.
Replace defective bulb of the charge
pilot lamp immediately.
The habit of touching a lead against the
frame to check whether it is live must
under no circumstances be used with
three-phase electrical systems.
When washing the engine, cover up
the alternator and regulator.
Use only the correct lifting tackle.
6.7.2 Three-Phase
Alternator
6.7 Accessories
SERVICE AND MAINTENANCE
6.7.3 Lifting Tackle
5.1.31
6.7.3 Ether Starting System
6.7.4.1 Changing the Fluid Container
Before removing the container, clean
the container support and the top of
the solenoid valve.
Loosen the bracket 1.
Unscrew the fuid container, 2.
Empty or replace the depressurized
fluid container.
Place the container, 1, on the
solenoid valve, 2 and tighten by
hand.
When mounting, ensure that
gasket, 3 is seated correctly.
Pull in the brackets.
Check for leaks.