3.
27. With both diff drop brackets installed, use jack to lift differential into place.
28. Use the provided 1/2”-13 x 3-1/2” bolts and laser cut washers for the driver side. (pic 11) And use
the provided 1/2”-13 x 1-1/4” bolts for passenger side. Torque all bolts to 60lbs. Make sure to double
check that all bolts are tight. Now reconnect all electrical wires and vacuum lines to front differential.
Make sure all wires and lines are out of the way of any moving parts.
9.
10.
11.
29. Install the new provided front driveline. Use the instructions within the driveline box.
30. Install the new provided front crossmember, using the factory hardware. Bolt heads should be
towards back of vehicle and the nuts facing towards the front. Now install the new rear cross-
member the same way. Using factory hardware and the bolt heads towards back of vehicle.
31. Now reinstall the factory lower control arms using the provided 18mm x 120mm bolts on the
front side (towards front of vehicle) and 18mm x 140mm on the rear side of the arms. (pic 12)
32. Before tightening up lower control arm, be sure to install the provided lower support rods.
12.
13.
33. Install new provided skid plate, using the provided 1/2”-13 x 4” bolt on the front crossmember
and 1/2”-13 x 1” bolt on the rear crossmemeber. After skid plate is installed, go back through and
tighten all hardware for front and rear crossmembers. Make sure lower A-frame support rods are
pushed up and flush againt welded tabs on crossmembers, before tightening. (pic 13) Also, make
sure lower control arms are parallel to the ground before tightening. Use a 27mm socket and wrench
to tighten.
