3 - 1
Mc28 Pit Bull
™
, No.824, No.1236, No.1648 &
No.2063 Fusion Machines
The Mc28 Pit Bull
™
and all MegaMc
®
machines except the
No.1236 require an adapter to mount the DataLogger
™
on the
bar surrounding the manual hydraulic controls. Install the
adapter in a convenient place on the bar. Tighten the adapter.
Loosen the thumbscrew on the back of the DataLogger
™
unit and
place the unit on the bar (1236) or on the bar adapter. Lightly
tighten the thumbscrew.
Remove the pressure transducer from the holder on the unit by
pulling down on the knurled collar on the quick disconnect.
Connect the pressure transducer quick disconnect to the fusion
machine quick disconnect.
Connecting To A Fusion Machine
NOTICE:
The fusion machine must have a hydraulic quick
disconnect for connecting the DataLogger
™
pressure transducer. If
the machine does not have one, contact your distributor for the
proper adapter or retrofit kit.
NOTICE:
Make sure the fusion machine hydraulic pump is turned
off and the pressure is at 0 psi before connecting the
DataLogger
™
to the fusion machine.
No.28, No.412 and No.618 Fusion Machines
Loosen the thumb screw on the back of the unit. Place the slotted
swivel adapter on the back of the unit over the top rectangular bar
around the hydraulic manifold. Position the unit on the bar and
lightly tighten the thumbscrew.
Remove the pressure transducer from the holder on the unit by
pulling down on the knurled collar on the quick disconnect.
Connect the pressure transducer quick disconnect to the fusion
machine quick disconnect.
Installation
PH01169-6-9-97
PH01168-6-9-97
PH01174-6-9-97
TX01338-4-15-99
TX01336-4-15-99
TX01337-4-15-99
PH01169-6-9-97
