CartPark Architectural |
Page 8 of 11
11
Installing the roof panels
Remove the protective film from both sides. From the outside of the
unit, slide both outer edges of the roof panel measuring 53.75” into
the grooves of the roof slope as shown. Slowly guide the roof panel
into place and be careful not to peel double sided tape on cross
member. Once near the top, guide the top edge of the roof panel
into the recessed area at the ridge as shown. You may need to push
roof panel up from the inside of the unit to allow it to slide into the
ridge groove.
Repeat this step to install the remaining roof panels.
12
53.75in
1365mm
55.13in
1400mm
Roof Slope
Ridge
Cross Member
Tape
Outer
facing out
Roof Slope
Cross Member
Push down along center
to adhere roof panels to
double sided tape.
Adhering Roof Panels to Roof Cross Members
Make sure the roof panels are clean and dry prior to peeling off
the double sided tape on top of the cross members. Peel off the
protective paper from the double sided tape on top of the cross
members. You will need to push panel upwards and away from
cross member. Press roof panel into the cross member from the
outside to make the panels adhere to the double sided tape.
Repeat for the remaining roof panels.
Important:
Make Sure all Roof panels adhere to the double sided tape on cross members.
