McAfee WebShield e500, Installation Manual

Page: 69 / 292

Installation Guide ENG - 59
Installation Guide — English
4: Automatic operation
determines which of the three options
above is suitable, and performs that option.
5: Perform a full installation and stop
removes all data from the
appliance’s hard disk drives and reinstalls the software. After
installation, the appliance ejects the CD but does not restart. You can
then turn off the appliance.
6: Reset passwords to factory default
returns the appliance’s
password to the default password
e500changeme
.
7: Do nothing and reboot leaves the appliance unchanged, and
ejects the CD. You might want to choose this option if you inserted
the CD by mistake, and do not want to restore or upgrade the
appliance’s software.
7. Enter the number for the required option.
You are asked if you want to continue.
8. Enter
Y
.
Unless you chose 7: Do nothing and reboot , the restoration or upgrade
process starts. A status screen shows the progress. Depending on the
option that you chose, the process can take up to 30 minutes.
WARNING: Depending on the option that you choose, the
appliance might revert to its default settings, losing the
configuration settings that you have made.
When the restoration or upgrade process has finished, the appliance
ejects the CD and restarts (unless you choose
5: Perform a full
installation and stop ). When it has finished its startup sequence
(after about two minutes), it is ready for use. Depending on the option
that you chose, you might need to reconfigure the appliance’s settings;
see
page 32 .
NOTE: When you access the appliance and log on, be aware that the
following changes might have occurred if you chose not to maintain
the previous settings (or they could not be maintained):
• The password has reverted to the default password
e500changeme
.
• The LAN1 port has reverted to the default IP address
10.1.1.108.
• The LAN2 port is enabled and has reverted to the default IP
address 10.1.2.108.
See Appendix A of the Product Guide for details on the appliance’s
default settings.