用户手册/
User's Manual
第
23
页 共
25
页
turning
确保驱动器工作正常，没有出现报警
Make sure the drive is working properly and there is no alarm
电机可以转动，但工作不正常
The motor can turn, but it
doesn't work properly
检查设置减速度和速度是否超过了设备极限
Check that the deceleration setting and the speed limit of the
equipment are exceeded
检查输出脉冲频率是否超过了驱动器的接收极限
Check if the output pulse frequency exceeds the receiving limit
of the driver
检查控制器和驱动器是否正确接地，抗干扰措施是否做好
Check the controller and driver are properly grounded,
anti-interference measures are done
脉冲和方向信号输出端光电隔离电路中使用的限流电阻过大，工作电
流偏小
The current limiting resistance used in the photoelectric
isolation circuit at the output of pulse and direction signals
is too large and the working current is too small
能够控制电机，但电机出现振荡
或是过冲
Can control the motor, but the
motor oscillates or
overshoots
可能是驱动器参数设置不当，检查驱动器参数设置
Drive parameter settings may be incorrect. Check drive parameter
settings
应用软件中加减速时间和运动速度设置不合理
The setting of acceleration and deceleration time and motion
speed is unreasonable in application software
能够控制电机，但工作时，回原
点定位不准
Can control the motor, but
work, back to the origin
location is not accurate
原点信号开关是否工作正常
Whether the origin signal switch is working properly
原点信号是否受到干扰
If the origin signal is being jammed
限位信号不起作用
The Stop Signal's not working
限位传感器工作不正常
The limit sensor is not working properly
限位传感器信号受到干扰
The limit sensor signal is jammed
扩展模块连接不上，扩展模块警
告灯亮
The extension module is not
connected. The extension
module warning light is on
检查 120 欧姆电阻是否有安装在两端
Check that the 120 ohm resistor is installed at both ends
检查是否有多个扩展模块采用同样的 ID
Check to see if multiple extension modules have the same ID
输入口检测不到信号
No signal detected at the
input port
检查 IO 电源有无供给
Check the IO power supply
检查信号电平是否与输入口匹配
Check if the signal level matches the input port
检查输入口编号是否与 IO 板的 ID 相匹配
Check that the input port number matches the IO board ID
输出口操作时没有反应
There is no response at the
output port
检查 IO 电源有无供给，IO 板上也要供电源
Check the IO power supply, IO board to power
检查输入口编号是否与 IO 板的 ID 相匹配
Check that the input port number matches the IO board ID
控制器网口连接不上
The controller network
网口的灯是否点亮？
Is the light on at the net port?
