6
Fig-3.3: MBMet-500CB Parts
Fig-3.4: MBMet-500DB Parts
4.
Solar Irradiation Transducer– Installation
Use the sensor mounting clamp provided along with the sensor to install it at side of the PV
module (or any other location). Care must be taken that the sensor inclination is same as PV
Module.
Step – 1:
Drill two holes (M6) at site where the Solar Irradiation sensor is intended to be
installed according to the following figure 4.1.
Fig – 4.1: Mounting holes’ dimension
Step – 2:
Install the sensor Mounting Clamp alongside the solar panel with the M5 x 32mm
screws, nut, spring washer and washer provided as shown in the figure 4.2.