10
FRONT SPEAKER INSTALLATION
This section covers temporary installation of the driver’s side speaker panel. Final installation of the speaker
panel occurs after the system is tested and gone through a thorough inspection prior to reassembly.
FRONT SPEAKERS
1
If the vehicle has the Smart-
Lok differential control module,
re-attach to the underside of
the new dash panel with the
original four 8mm screws.
3
4
Ensure the clip retainers and
washers from the original dash
panel are installed correctly
and in place before proceeding.
Connect driver’s side speaker
to white speaker wiring near
the amplifier harness area.
Red/black wires are for optional
illuminated speaker rings.
Set panel temporarily in place
without attaching any hardware
or clips. Do not yet plug in
switches in case subwoofer
amplifier adjustments are
needed.
8mm
Screws
DRIVER SIDE SPEAKER CONNECTIONS
● SOLID WHITE - Left Front Speaker (+)
● WHITE/BLACK - Left Front Speaker (-)
● RED - Illumi (Optional Grille Required)
● BLACK - Illumination -
2
DOUBLE CHECK INSTALLATION STEPS TO THIS POINT
Take a few minutes to double check all of the installation steps to this point ensuring the amplifier, subwoofer
and wiring has all been connected as shown in these instructions.
NOTE ABOUT AFTERMARKET ROLL CAGES
Although MB Quart front speakers come pre-installed in the Can-Am replacement panels, they may require
removal from the panel to fit low-slung aftermarket roll cages that fit close to the hood area.
In these cases where fit is tight or would damage the speaker due to the roll cage position, remove the
speaker from the panel first, install the panel in the vehicle, then connect and install the speaker into the
panel.
PROCEED TO THE NEXT PAGES TO CONFIRM SETTINGS AND BEGIN TESTING THE SYSTEM.
