14
REASSEMBLY
VEHICLE REASSEMBLY
As you begin reassembly, take the time to ensure no fastener, screw or clip is excluded. Review any prior
disassembly steps to ensure you don’t miss any hardware during reassembly.
2
Plug in all switch wiring on
back of the driver side front
speaker panel. Test switch
functions to ensure they are
correctly connected.
Place driver side speaker panel
into its final position*. Check fit
so that all open hardware and
clip holes are aligned properly.
1
*AFTERMARKET ROLL CAGES
Although MB Quart front speakers
come pre-installed in the Can-Am
replacement panels, they may
require removal from the panel to
fit low-slung aftermarket roll cages
that fit close to the hood area.
In these cases where fit is tight or
would damage the speaker due to
the roll cage position, remove the
speaker from the panel first, install
the panel in the vehicle, then
connect and install the speaker
into the panel.
Secure the front speaker panel by reinstalling all the remaining clips and T-30 hardware in the same
locations removed during the disassembly process. Do not forget about reinstalling the additional
hidden push pin under the driver’s side dash, between the steering wheel and console, just forward of
the tubular chassis support.
3
Reinstall the gauge panel with the two T-30 screws and two 10mm nuts. With this step completed, the
driver side front speaker panel installation should be complete.
4
Place the source unit’s housing in its center dash installation location with wiring neatly secured and
zip tied in place. Attach the four T-25 Torx screws through the housing’s mounting holes into each of
the four locations originally drilled out for mounting during the Stage system install. Two T-25 32mm
screws in the front of the housing and the shorter two T-25 24mm screws in back.
7
Reinstall two T-30 screws in the upper center dash (on the driver side) forward of the fuse panel. Once
complete, reinstall the upper center dash access cover behind source unit housing. Refer to page 4 for
disassembly steps and simply do these in reverse.
8
6
If removed during disassembly, reinstall driver and passenger center console side panels by gently
snapping back into place. Ensure no wiring is exposed or pinched. Refer to page 4 for disassembly
steps and simply do these in reverse. Otherwise, skip this step.
9
Reinstall driver and passenger seats with the original 18mm bolts in the rear and 13mm bolts/nuts in
the front. Refer to page 3 for disassembly steps and simply do these in reverse.
Ensure the harnesses you connected to the subwoofer amplifer are secured to factory wiring with
zip ties. Do not zip tie any part of the audio harness or the RCA audio cables to any heat or moisture
sources, or to any moving parts.
5
