5
VEHICLE DISASSEMBLY
This section covers left and right side top dash speaker panels and gauge cluster removal.
REMOVE PASSENGER & DRIVER TOP DASH PANELS
2
3
Remove gas filler access door
on passenger side. Note above
the grommet for the retainer
clip, there is a 10mm nut
attaching a mounting screw.
Remove three T-30 screws
from the top edge of the
passenger’s side dash where
the hood line meets the dash
as indicated.
Remove the remaining two
T-30 screws on the side
edge of the panel. The top
screw requires the 10mm nut
loosened with a 10mm socket.
5
6
Gently remove passenger side
speaker panel and set aside.
The center push pin retainer
clips will eventually need to be
transfered to the new panel.
Drop steering wheel position
to access two T-30 gauge
cluster screws. Cluster removal
helps removal of the panel and
access for amplifier installation.
Remove two T-30 screws
holding the gauge cluster with
a 10mm socket (below) and
T-30 driver (above). Set gauge
cluster aside when done.
7
8
9
Remove three T-30 screws
from the top edge of the
driver’s side dash where the
hood line meets the dash as
indicated.
Remove two T-30 screws on
the side edge of the panel.
Next, remove two remaining
T-30 screws behind gauge
cluster area as indicated.
Pull panel* carefully to access
switches and unplug them to
fully remove driver’s side panel.
Set aside as with passenger
dash panel for later reuse.
DISASSEMBLY
1
4
10mm nut
on back
side
These retainers
will be reused
*Note: If equipped with Smart-Lok differential feature, remove the module with four 8mm screws from underside of driver’s dash panel.
