9
1030658 Rev.A 09/05
IMMOBILIZER INTERFACE RIBBON CABLE MOUNTING
8
1. Route the immobilizer interface (previously installed) ribbon cable
to the ignition switch, making sure to keep it away from any moving
parts.
2. Following the instructions on the supplied ampule of adhesive primer,
apply a thin coating to the entire transceiver antenna ring (black plastic
ring around key switch, FIGURE GG) and to the ribbon cable.
3. Remove the backing from one side of the supplied 2-way tape and apply
tape around the transceiver antenna ring (black plastic behind ig-
nition switch) keeping the tape off of the rounded part of the igni-
tion switch face and trimming excess 2-way tape if necessary.
4. Remove the remaining backing on the 2-way tape and position the
ribbon cable around the transceiver antenna ring, with the striped
side facing the ignition key opening. (FIGURE HH & II)
5. Using a supplied tie wrap, secure the antenna coil.
.
(FIGURE HH & II)
FIGURE GG
FIGURE HH
FIGURE II
WIRE HARNESS CONNECTIONS- STEERING COLUMN
9
IGNITION SWITCH CONNECTOR (C-456 CONNECTOR)
2. Route the remote start ignition harness with 8-way male and fe-
male ignition connectors and 12-way male and female multifunction
switch connector, transponder interface wiring and ribbon cable
across and up the left of the steering column harness, do not secure
harness at this time.
3. Locate the 8-way WHITE and GREY ignition connector, on the left
side of the steering column.
4. Release the GREY secondary latch and remove the 8-way WHITE
ignition connector by pulling upwards.
5. Plug the remote start harness 8-way WHITE female connector into
the factory ignition switch, replace the GREY secondary latch and
secure harness in place. (FIGURE JJ)
6. Connect the remote start harness 8-way male connector into the
factory ignition harness, and replace the GREY secondary latch.
(FIGURE KK)
FIGURE JJ
FIGURE KK