17
GPS & TEL
Antenna Cables
MMS Harness
Vehicle
Harness
2 x Wire Ties
(White)
3 x Wire Ties (White)
Vehicle Harness
30. Secure the MMS Harness to the Vehicle Harness using 1
wire tie (white).
31. Secure the MMS Harness to the Vehicle Harness along
the lower HVAC area using 2 wire ties (white).
32. Route the MMS Harness along the rear side of the Vehicle
Harness and secure using 1 wire tie (white).
33. Secure the Antenna Cables and MMS Harness together
with the Vehicle Harness using 1 wire tie (white).
29. Plug in MMS harness 2P connector to Vehicle Harness
2P Pre-connector.
•
The 2P Pre-connector is located either in front or back of
the vehicle harness depending on vehicle specs.
Note
2P Pre-connector in
front of Vehicle harness
MMS 2P
Connector
MMS 2P
Connector
2P Pre-connector in
back of Vehicle harness
MMS ECU Installation
34. Apply 1/2 Urethane foam tape on the MMS ECU.
35. Rotate the MMS ECU and apply 1 Urethane Foam tape as
shown.
1/2 Urethane
foam tape
1 Urethane
foam tape
MMS ECU
MMS ECU
