16
25. Continue routing the Antenna cables from the A-pillar
behind the IP reinforcement bar.
26. Secure the Antenna Cables along the Vehicle Harness
using 2 wire ties (white).
GPS & TEL Antenna Cables
IP reinforcement bar
2 x Wire Ties (White)
1/2 FH Protection sheet
1/2 FH Protection sheet
20. Cut the FH Protection sheet in half.
21. Wrap the Antenna cables starting from the bottom of the
A-pillar using the 2 pieces of 1/2 FH Protection sheet.
22. Secure the FH Protection sheet using electrical tape.
23. Secure the GPS & TEL Antenna Cables to the vehicle
harness using 2 wire ties (white).
24. Route both GPS & TEL Antenna Cables down towards the
Glove box area.
Vehicle right
GPS & TEL Antenna Cables
2 x Wire Ties
(White)
Vehicle's Right
MMS Harness Installation
27. Install the MMS harness Ground terminal to the Vehicle
ground terminal bolt.
Bolt tightening torque: 8.8 - 12.7 N•m (6.4 - 9.3 ft•lbf)
28. Secure the MMS Harness Ground wire to the Vehicle
Harness using the 1 wire tie (white).
Ground
location
Wire Tie
(White)
MMS harness
Vehicle
harness
