12
M. AUX CONTROL BOX CONNECTIONS AND MOUNTING
1. Remove AUX Control Module and vehicle AUX harness
from the installer prepack.
2. Connect the 14 pin connector of the AUX Harness to
the corresponding connection point on the AUX Control
Module.
3. Connect the 3 pin connector from the AUX Cable that
is in the center console and previously pulled from the
driver’s side to the AUX Control Module.
4. Disconnect the male OEM AUX port connector and
connect to the female connector of the RSES Vehicle
AUX harness. (Figure 22)
5. Connect the male connector of the RSES AUX Harness
into the female OEM AUX port. (Figure 21)
6. Clean the inside left panel in the location illustrated in
Figure 21 and adhere primer.
7.
Remove the protective film from the 2-sided tape on
the AUX Control Module and adhere to the location
illustrated in Figure 22.
8. Route the vehicle AUX Harness as shown in Figure 22.
9. Tie wrap the vehicle harness to GMSL and Power cable
to the left of the Christmas tree connector, as illustrated
in Figure 23.
!
CAUTION – Do not contact, or secure RSES
wiring to wireless transmitter, or obscure transmitter
in any way!
Figure 21
12345671213
Figure 22
Figure 23
RSES Aux Harness to OEM
AUX Port
AUX
Module
!
Wireless Transmitter
Tie wraps
OEM AUX and RSES Connection Point
