7
4280159 Rev. A 10/10
HOOD SAFETY SWITCH MOUNTING
1. Using (2) supplied, 1/4” self drilling screws and (2) supplied lock washers, secure the hood safety
switch to the drivers side of the vehicle’s hood 105 mm above the top of the hood mounting bracket
and 70 mm from the side edge of the hood. (FIGURE P & Q)
2. Route the hood safety switch wiring down into the engine compartment along the inside of the
hood hinge and secure using (1) supplied, short wire tie. (FIGURE Q)
3. Remove the plastic phillips screw in cowl panel to route the hood safety switch wiring underneath.
Gently lift the cowl panel and tuck hood safety switch wiring under the cowl panel and into the
engine compartment. Continue routing toward the main wire harness grommet in the vehicle
dashwall. (FIGURE P & R)
5
FIGURE P
FIGURE R
FIGURE Q
Hood Safety
Switch Wiring
Hood Safety
Switch Wiring
Phillips
Screw
Wire
Tie
105 mm
70 mm
