Page 10 of 10
Date
Vehicle
VIN
Checked
Person in
Charge
If the battery is disconnected, the power windows may no longer fully open or fully
close automatically.
1. Turn the ignition key to the “ON” position.
2. Press the power window switch to fully open the power windows.
3. Lift up the power window switch to fully close the power windows, and keep it pulled up
for approximately 2 seconds.
4. Position the engine switch at “OFF”, and then at “ON” again. When the function doesn’t work
after these procedures, please contact your Mazda dealer.
CAUTION
!
If
the battery is disconnected, the DSC may stop operating.
(The DSC OFF indicator will flash at this time, and the TCS/DSC operation indicator will illuminate.)
1. Turn the ignition switch to “OFF” and then turn it back to “ON”.
2. Turn the steering wheel clockwise as far as it will go, and then turn it back counterclockwise as far as it
will go.
3. Check that the TCS/DSC operation indicator is turned off.
4. Turn the ignition switch to “OFF” and then turn it back to “ON”.
5. Check that the TCS/DSC operation indicator is turned off. If the TCS/DSC operation indicator is still
illuminated or the DSC indicator is not turned off when the ignition switch is turned back to “ON”, contact
your Mazda dealer.
CAUTION
!
CAUTION
!
1. After performing Step 1 on page 5, verify that a minimum of 50mm has been achieved
between exhaust and harness. If not, remove tie wrap and repeat Step 2
using a new tie wrap. If 50mm has been achieved, move on to Step 3.
Due to the extreme high temperatures produced by the exhaust, a minimum
clearance of 50mm must be maintained between exhaust and harness. Failure to do
so will result in severe damage to harness and loss of trailer functions, such as
brake light and turn signal lights.
