Maytag MAH6700AW Series, Service

Page: 64 / 68

B-14 16026186
©2006 Maytag Services
Washers can be damaged if water is not removed from hoses
and internal components before storage. Prepare the washer
for storage as follows:
• Select the Quick Wash cycle and add bleach to the
automatic dispenser. Run the washer through the cycle
without a load.
• Turn the water faucets off and disconnect the inlet hoses.
For information on long-term storage or storage of your
washer during extreme cold temperatures,
call Customer Service toll-free at
1-800-688-9900 USA or 1-800-688-2002 Canada.
U.S. customers using TTY for deaf, hearing impaired or
speech impaired, call 1-800-688-2080.
S
TORING THE
C
LOTHES
W
ASHER
T
ROUBLESHOOTING
• See Cleaning the Interior, page 11.
• Make sure door is firmly closed.
• Make sure the washer is plugged in.
• Make sure the water source faucets are turned on.
• Make sure to press the
Cycle Selector dial to start the washer.
• Make sure the Control Lock is not activated, see page 6.
• Before the washer starts to fill, it will make a series of clicking noises to check the door lock
and do a quick drain.
• Turn both faucets on fully.
• Make sure the door is tightly closed.
• Make sure the washer is plugged in.
• Check fuse or reset circuit breaker.
• Press the
Cycle Selector dial to start the washer.
• Straighten water inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Open and close the door, then press the
Cycle Selector dial.
• Make sure the washer is running with sufficient water pressure.
See Installation Instructions.
• Make sure the Detergent Selector is in the upper position when using granular detergent.
• Make sure the washer is set on a level surface. If the surface is not level, adjust the washer
feet to level the appliance. See Installation Instructions.
• Make sure that the shipping bolts are removed. See Installation Instructions.
• Make sure the washer is not touching any other object.
• Make sure the laundry load is balanced.
W asher vibrates or
is too noisy
Detergent remains in
the automatic
dispenser after the
wash cycle is complete
No water or
insufficient water
supply
The washer will not
start
C
ONT
.
• Disconnect the clothes washer from the electrical
supply and leave the washer door open to let air
circulate inside the tumbler.
• If the washer has been stored in below-freezing
temperatures, allow time for any water left over in the
washer to thaw out before use.
C
HECK THESE POINTS IF YOUR
M N
EPTUNE
®
W
ASHER
...
Freshening your
washer
AYTAG