Disassembly Procedures
To avoid the risk of electrical shock, personal injury or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
WARNING
!
©2004 Maytag Appliances Company
16023053 Rev. 0
25
7. Disconnect wires from fan motor terminals.
8. Carefully note fan blade direction and placement on
motor shaft.
9. Pull fan blade from motor shaft.
10.Remove screws securing motor to shroud and
remove motor.
11. Reassemble in reverse order.
Motor
Fan shroud
Rear air guide
Blade
Cavity Thermostat
The cavity thermostat is located on top left side of cavity.
Thermostat is a non–resettable thermostat.
1. Disconnect power to oven and remove outer case,
(see "Outer Case" section).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Carefully bend one tab to release thermostat.
4. Disconnect wires from oven thermostat and replace
thermostat.
5. Reassemble in reverse order.
Light Socket / Bulb Assembly
1. Disconnect power to oven and remove outer case,
(see "Outer Case" section).
2. Disconnect wire terminal plug.
3. Carefully bend one tab to release socket.
4. Remove light socket / bulb assembly.
5. Replace and reassemble in reverse order.
Antenna
1. Open oven door to gain access to oven tray.
2. Using suction cup tool (59001235). Remove oven tray,
by placing suction cup on oven tray and raising oven
tray and removing it from the oven cavity.
3. Remove center portion of plastic insert from plastic
rivet.
4. Lift upward on antenna to remove.
5. Reassemble in reverse order.
NOTE:
When replacing antenna push outer portion of
plastic rivet flush with the bottom of new antenna.
Place new antenna onto stirrer shaft, align rivet
holes and push rivet into place. Once rivet is in
place inner insert into rivet.
Stirrer Motor
1. Disconnect power to oven.
2. Place oven on it's back.
3. Remove bottom plate cover, by cutting metal tabs
NOTE:
When reinstalling plate cover use screw
provided.
4. Disconnect wires from motor terminals.
5. Remove screws securing motor to oven cavity.
Stirrer motor
Wire leads
6. Replace and reassemble in reverse order.
