2-14
12
Examine the leveling legs. Find the diamond marking.
32
Screw the legs into the leg holes by hand. Use a wrench to
finish turning the legs until the diamond marking is no longer
visible.
42
Place a carton corner post from dryer packaging under each
of the 2 dryer back corners. Stand the dryer up. Slide the
dryer on the corner posts until it is close to its final location.
Leave enough room to connect the exhaust vent.
1232456726
Check the levelness of the dryer. Check levelness first
side to side, then front to back.
If the dryer is not level, prop up the dryer using a wood block.
Use a wrench to adjust the legs up or down and check again for
levelness.
8922
52
Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in
dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Check that the vent is secured
to exhaust hood with a 4" (10.2 cm) clamp.
62
Move dryer into its final location. Do not crush or kink vent.
12
(On gas models) Check that there are no kinks in the flexible
gas line.
32
Once the exhaust vent connection is made, remove the
corner posts and cardboard.
232625996
You can change your door swing from a right-side opening to a
left-side opening, if desired.
29322996
52
Open the dryer door. Remove the 4 screws that hold the door
hinge on the front panel of the dryer. Loosen, but do not
remove, the screw with the top keyhole opening last (second
from the top).
62
Lift and pull forward on the door so that the keyhole clears
the screw head. Remove the door.
12
Lay the dryer door on a flat, protected surface with the inside
door assembly facing up. Remove the last screw from Step 1.
Remove the 2 screws holding the handle to the door.
32
Remove the 6 screws to release the outer door assembly
from the inner door assembly (see illustration). It is important
that you remove only the 6 indicated screws.
42
Lift the inner door assembly off of the outer door assembly.
Unsnap the handle from the outer door assembly, move it to
the other side, and snap in. Set the outer door assembly
aside.
2326222262
52
Place the inner door, screw head side up, on the work
surface.
62
Remove the 4 screws that hold the hinge to the door.
12 34564
72 3898946862
2 345649884
Summary of Contents for Epic MED/GD9600S
