Control Testing Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power and gas to range before servicing,
unless testing requires power and/or gas.
May 2006
16027222
© 2006 Maytag Services
Replaces 16022499
5
"Quick Test" Mode for M1 Electronic Range Control (ERC)
Follow procedure below to use the quick test mode. Entries must be made within 32 seconds of each other or the
control will exit the quick test mode.
1.
Press and hold
CANCEL
and
BROIL
pads for 3 to 5 seconds.
2. Once the control has entered the "Quick Test" mode, release both pads.
3. Press each of the following pads indicated in the table below.
NOTE:
Pressing the pad once activates the response.
Press the pad a second time deactivates the response.
NOTE:
This mode must be entered within the first 5 minutes of power up.
NOTE:
If the temperature sensor reaches 400° F, the Quick Test mode will be disabled.
Display will indicate the following:
Key Operation
[Bake]
Bake
relay activated
[Broil]
Broil
relay activated
[Keep Warm]
N\A
[Cook&Hold]
Last Diagnostic Code displayed
[Clean]
MDL
relay activated (lock and unlock)
[Delay] (M1)
EEPROM Version Number
displayed
[Timer]
Main Code Version Number
displayed
[Clock]
All
Segments
On
[More +]
Even Segments
On
[Less –]
Odd Segments
On
[Cancel]
End Factory Test Mode
Description of Error Codes
Error diagnostic codes can only be viewed by entering the Diagnostic Code Display Mode.
Each error code is four digits long and is created based on the following table.
Digit Description
1
st
Primary System:
1 – Local to the control circuit board
3 – Sensor or meat probe
4 – Control input
9 – Door lock
2
nd
Measurable:
d – Diagnostic: measurable parameter
c – Control related, replace control
3
rd
Secondary
System:
Sequential
numbering
4
th
Oven Cavity:
1 – Upper oven (or single cavity oven)
2 – Lower oven
c – Control specific
Diagnostic Code Display Mode can be activated by
pressing and holding
the
AUTOSET
pad for 3 to 5 seconds at
power-up.
Diagnostic Code Display Mode can only be started while powering up the control.
