Other Functions
DRM 2010 Operating Instructions, Revision Level 03/2004
7
UK
D
Using the Antenna
The device has an installed ferrite an-
tenna for receiving long, medium and
short waves. To improve reception of
these frequencies, the receiver can be
connected to an appropriate outdoor
antenna. For this purpose, there are
two antenna sockets on the left short
side of the device. The upper socket
LOOP ANT is reserved for a loop an-
tenna, the lower one WIRE ANT for a
long-wire antenna.
For the reception of VHF (FM) a pop-
up antenna has been installed.
USB-output
In the case of DRM-reception, you can
choose which service component is to
be issued on the USB-output.
●
Press USB; now the display is
showing the current setting.
●
With SC UP or SC DOWN, you can
change through the received serv-
ice components.
●
To choose the shown service com-
ponent, press USB again.
If you have chosen OFF, the USB-out-
put will be switched off.
Firmware Version
In order to see the firmware version in-
stalled,
●
unplug the adapter if needed,
●
press and hold SC UP and
●
plug the adapter into the corre-
sponding socket of the receiver.
The display is now showing a charac-
ter string, e.g. A071V01Z. The part af-
ter the "V" (here: "01Z") indicates the
firmware version.
Technical Data
Size
21 x 7 x 13 cm
Outputs
3,5 mm micro sockets for
stereo headset and stereo
Line
Inputs
3,5 mm micro sockets for
loop antenna and for long-
wire antenna
Control
USB-interface for digital da-
ta services (output) and SW-
updates (input)
Power supply External switching power
adapter, 100-240 VAC, 47-
67 Hz, 1000 mA
Weight (with-
out adapter)
ca. 700 g
Weight of
adapter
ca. 500 g
