On/Off - Volume - Receiving Mode - Frequency
DRM 2010 Operating Instructions, Revision Level 03/2004
3
UK
D
Switching Device on and off
In order to switch on the device,
●
plug adapter into power line socket,
●
plug the jack of the adapter into the
socket DC IN on the left short side
of the device and
●
press RADIO ON/ OFF on the front
side.
In order to switch off the device,
●
press RADIO ON/ OFF again.
If receiver is switched on, the dis-
play is shining. Light goes out when
receiver is switched off.
If the device is switched off and
connected with the mains power
adapter, the unlit display shows
STAND BY.
When switching off, the device
saves the latest tuned frequency in
every receiving mode, with DRM
also the latest station adjustment
(preset). When the device is
switched off and then later on
again, the same programme, with
DRM the same station adjustment
appears as before switching off.
Adjusting Volume
Volume of speaker or headset
plugged in, can be set by thumb wheel
VOLUME on the right short side of the
device.
The LINE OUT on the right short
side of the device is not influenced
by that.
In case headset is plugged into the
corresponding socket on the left
short side of the device, the built-
in-speaker will be deactivated.
Choosing Receiving Mode
With the mode switch on the right
short side of the device (DRM/ AM/
FM) you can switch between FM
(VHM), AM (analogue long, medium
and short wave) and DRM (digital
long, medium and short wave).
Frequencies:
– AM/DRM: 150 kHz - 29.999 kHz
– FM: 87,50 - 108,00 MHz
The device cannot receive fre-
quencies outside of these areas.
Setting Frequencies
If the preset mode (see page 5) is
switched off, you can set frequencies
in three different ways:
1) Entering exact frequency via digit
key.
2) Using automatic station search.
3) Shifting frequency.
