top end cap
supporting cap
bottom end cap
Assembly: Unpacking the parasol
1. Remove bottom end cap of the front part of the cardboard sleeve. Use a cordless screwdriver with
a T30 bit to remove the torx screws.
Pulling out the parasol from the cardboard sleeve may damage the canopy.
The torx screws that hold the end cap of the carboard sleeve may cut the canopy while it’s been
pulled out.
• Each cap is secured with 4 torx screws. Make sure to remove all 4 torx screws before pulling
out the parasol.
2. Remove the accessory package (crank, MAY-protective gloves), the protective sleeve and the printout of
the operating manual attached to the centre pole.
3. Remove the inner support cap the same way as the end cap.
4. Remove the top end cap. This is not required but helpful as it avoids the development of a vacuum
within the cardboard sleeve during pulling out the parasol. This would complicate pulling out the
parasol.
5. Pull at the centre pole to pull out the parasol of the cardboard sleeve.
Caution
Stand 38-1408
Deutsch /
English
/ Français
page 5 of 22
