Electric Juicer
EN
11
USE
Set-Up and Connection
Please Note!
■
Inspect the device for damage each
time before you use it. The device
should only be used if it has been
fully assembled, is undamaged and in
working order!
■
Only connect the device to a plug
socket that is properly installed. The
plug socket must be readily accessible
so that the connection to the mains
can quickly be isolated. The mains
voltage must match the technical data
of the device.
■
Lay the connecting cable so that it
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces.
1. Place the motor unit (
5
) on the kitchen
unit or another dry, clean and flat
work surface.
2. Place the juice container (
6
) in the
motor unit.
3. Place the collecting bowl (
4
) on the
motor unit and twist it if necessary
until it locks in place. The juice outlet
(opening) in the collecting bowl must
be located over the juice container.
4. Insert the strainer (
3
) into the
collecting bowl.
5. Plug the press cone (
2
) onto the drive
shaft in the middle of the collecting
bowl.
6. Fully unwind the connecting cable
and plug the mains plug into the plug
socket.
Picture B
shows the fully assembled
device.
The device is
taken apart
in the reverse
order.
Squeezing Juice
Please Note!
■
This appliance may be operated
under both 50 Hz and 60 Hz without
any adjustment.
■
Do not move the device during
operation. Ensure that it is stable!
■
Keep the device clean.
■
After approx. 15 seconds of constant
operation, pause for 15 seconds
to ensure that the motor is not
overloaded.
1. Wash and halve some fruit.
2. Place one half of fruit on the press
cone and press it down (
Picture C
).
The pressure causes the device to
switch on and the press cone rotates.
3. Stop applying pressure to stop the
device (
Picture D
).
4. To change the direction of rotation,
press down again and operate the
press cone.
The direction of rotation is
automatically alternated each time
you start the device.
5. If the strainer is blocked by pips and /
or pulp, remove the strainer and clean
it.
6. Serve the squeezed juice (
Picture E
).
7. Clean the device immediately after
use so that the pulp does not dry
on (see the “Cleaning and Storage”
chapter).
