EN
14
BEFORE INITIAL USE
• Assemble the device (see the “As-
sembling the Device” chapter).
• Charge up the battery (see the
“Charging Up the Battery” chapter).
ASSEMBLING THE DEVICE
PLEASE NOTE:
Flip up the stem
mount (
5
) on the main unit (
A
). It must be
upright so that the device is deactivated
and cannot be switched on accidentally.
1. Insert the tube parts
(2 – 4
) into one
another as follows: tube >connecting
piece > tube. You must hear each
part engage in the other.
2. Plug the handle (
C
) onto an alumin-
ium tube at the top. It must engage
audibly.
3. Plug the stem with the handle into
the stem mount on the main unit. It
must engage audibly.
To remove the stem, the handle or the
individual tube parts, press the corre-
sponding release buttons in each case
and pull out the respective part.
Attaching / Detaching Mop Pads
Please Note!
■
The mop pads must not be attached
to the cleaning feet when they are
wet.
•
Attaching:
Attach one mop pad (
F
) in
each case to a cleaning foot (
8
) using
the hook and loop fastener.
•
Detaching:
Pull the mop pads off the
cleaning feet (
Picture C
).
CHARGING UP THE
BATTERY
Please Note!
■
Risk of short-circuits!
Do not insert
any conducting objects (e.g. screw-
drivers or similar items) into the
charging socket.
■
Only connect the mains adapter to a
plug socket that is properly installed
and matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
Pull the mains adapter out of the plug
socket if it is not going to be used for
a lengthy period of time.
■
It is essential that you charge up the
battery fully before you fi rst use the
device in order to achieve the maxi-
mum charging capacity.
1. Flip up the stem mount (
5
) on the
main unit (
A
). It must be upright so
that the device is deactivated and
cannot be switched on accidentally.
2. Open the protective cover for the
charging socket (
6
) on the main unit
and connect the barrel connector of
the mains adapter (
B
) to the charging
socket.
3. Connect the mains adapter to a
properly installed plug socket that is
easily accessible. The battery status
display (
7
) fl ashes (• 30%, •• 65%, •••
100% charge).
The battery is fully charged when
the battery status display lights up
permanently
.
4. Disconnect the mains adapter from
the mains power and then from the
main unit.
5. Close the protective cover for the
charging socket again.
