ENGLISH
11
•
The best haircutting results are reached
on dry hair, not wet.
•
Set the hair with the comb (7) to reveal
uneven locks.
•
It is better to leave longer hair after cutting
for the first time.
•
As you learn the hair clipper better, you
will be able to model desired haircuts
yourself.
Attachment comb (3):
Install the attachment comb (3) inserting the
ledges of the attachment into the grooves on
the unit body.
The cutting length depends on the position
of the attachment comb (3). Shift the attach-
ment to the required length by pressing on the
clamp on its rear part:
•
position “6” – hair length 6 mm,
•
position “8” – hair length 8 mm,
•
position “10” – hair length 10 mm,
•
position “12” – hair length 12 mm,
•
position “15” – hair length 15 mm,
Step one
Set the attachment comb (3) to the posi-
tion “6”. Switch the hair clipper on with the
switch (1). Hold the unit with the blades
pointed upwards. Start haircutting from
the beginning of the hair growth. Slowly
move the clipper upwards. Cut the head
back area at the bottom and near the ears
(pic. 1, 2, 3).
Step two
Switch the hair clipper off and set the attach-
ment comb (3) to the position “10” or “12”,
switch the hair clipper on and continue
cutting hair closer to the top of the head
(pic. 4).
Step 3 – cutting temples
Switch the hair clipper off, set the attachment
comb (3) to the position “6” and cut hair on
the temples. Then set the attachment comb
(3) to the position “10” or “12” and continue
cutting towards the top of the head.
Step 4 – cutting the top of the head
Using the position “10” or “12”, cut the hair
from the top of the head towards the crown
against the hair growth direction.
Notes:
•
You can cut hair against and along the
direction of hair growth, but keep in mind
that the hair cut against the growth will
be shorter.
•
To leave longer hair, take hair locks
between your fingers and cut hair using
the clipper (pic. 5).
•
You can use the comb (7): lift the hair
locks and cut them with the hair clipper
above the comb (pic. 6).
•
Always start cutting from the back of the
head.
•
Set the hair with the comb (7) to reveal
uneven locks.
•
Use the scissors (8) to make haircut even.
Step 5 – the final part
Remove the attachment comb (3) from the hair
clipper, turn the blades of the clipper towards
the hair and trim hair on the temples and neck
carefully. Do not press the clipper strongly,
there is danger of injuries or cuts when open
blades come in contact with skin (fig. 7).
Cone-shaped haircut
Set the attachment comb (3) to the necessary
position and start cutting from the head back
towards the top. Cut hair against hair growth
direction from the head front to the top and
on the head sides (pic. 8). To get a flat top
haircut, use the comb (7): lift the locks and
cut them along the comb. Set the hair with the
comb (7) to reveal uneven locks.
CLEANING AND CARE
Cleaning the blades (2)
Regularly clean and lubricate the shaving
block (2) using the oil (9) supplied with the
unit.
–
Switch the hair clipper off using the switch
(1), unplug it if the unit is being charged.
–
Remove the attachment comb (3).
MW-2109_105 x148.indd 11
15.01.2014 15:37:33
