13
Activate the device until you get 3 good or fair results in a row. Wait 10 seconds
between each test on the same device. You may mount wireless devices where
results were good or fair.
Devices indicating a bad result must be moved to another location. You may
only have to move the device a few inches to correct a bad result.
NOTE
: Do not mount any device where a “bad” test result was indicated.
If several wireless devices produce BAD test results, you may need to move the
PC4164-RS to a better location. (See section 2.3 for tips on finding a location for
the PC4164-RS.)
8. To test another device, press [#] once, then repeat steps 4 - 7. Continue to test
the devices until both the PC4164-RS and the devices are in good or fair locations.
9. To exit installer programming, press [#].
4.2 Test WLS908, WLS909 and WLS910 Reception
The panic pendant (WLS908), wireless key (WLS909) and handheld keypad
(WLS910) cannot be tested using the module placement test described above. To
ensure that the PC4164-RS is receiving transmissions from these devices, conduct
the following tests:
WLS908:
Activate the Panic alarm at several different points in the installation.
WLS909:
Use the function keys to arm and disarm the system at several different
points in the installation.
NOTE
: Do not use a Fire, Auxiliary or Panic key to test your WLS909 as pressing these
buttons will
always
notify your central station of a non-medical emergency.
WLS910:
Use the keypad to arm and disarm the system from several different
points in the installation.
If these devices do not operate from all points in the installation, you will need to
move the PC4164-RS receiver. Moving the PC4164-RS higher will usually improve
the reception.
If you move the PC4164-RS, repeat the tests described in sections 4.1 and 4.2 on all
the wireless devices. Continue to test the devices until you have found locations
with good or fair placement results for the PC4164-RS and the WLS904, WLS905,
WLS906 and WLS907 devices, and there is acceptable range between the PC4164-RS
and the WLS908, WLS909 and WLS910 devices.
T E S T I N G & M O U N T I N G D E V I C E S
